Old Trayon setup and mods

[Falkon]

Hi Ross, the panels are approx 8mm thick including the aluminium skin on the outside. I was going to use the cut outs as well but decided to go with the chequer plate because I thought that the plywood panel edges could be prone to getting water in them over time and rotting plus they would stick out too much with the aluminium door seal I got. Also the reason I chose the door seals was because they have a nice fat seal to stop water and dust from entering the storage areas. These seals are used in office buildings with aluminium frames and doors and are designed to clip into the door frame. So when they do office reno's these end up at recycling centrs.
Hope that helps
Cheers.