Old Trayon setup and mods

[Falkon]

Hi ya Rossel, glad you liked it. Ok with the hatches I used aluminium door seal extrusions, I got from our tip recycle centre, to make the frames. They came with nice rubber seals and were cheap. Then just cut some aluminium chequer plate for the doors. The hinges were some piano Hinges I got from Bunnings and the to lock up I used compression locks bought on Ebay. To make sure I cut out the opening in the right place I marked them out on the inside and drilled small holes in the corners. Then simply cut out the panel from the outside with a jig saw. The large hatch next to the entry door was a similar technique but I bought a commercially made insert on Ebay from a local caravan supplier. This normally would go in the other way around and provide a nice drop down table but since I carry my winch in there I mounted the hatch upside down. Pretty straight forward and comes with instructions. Hopefully this and my photos in owner mods forum give you some idea.
Cheers
Bob